SKU: EKAB10024B1
Znamka: EK archery
Strelni daljnogled 4x32 (samostrel, rail 22)
Strelni daljnogled osnovne serije s križem prilagojenim za strljenaje s samostreli.
Regulator pritiska za PCP zračno puško hatsan. Podpira modele BT65, Gladius, Galatian II, Flash. Regulator ne poveča moči ampak zagotavlja konstantne pritiske in s tem poveča natačnost.
Navodila za instalacijo so v video zapisu.
Correct clean air tube and regulator
Install regulator
Unfortunately Youtube deleted our channel, we will try make new video soon.
In the meantime:
Video instalation is very simalar with P12 ( after second minute ), most important part is remove o-ring from valve. By removing o-ring you create venting hole for regulator.
Setting output pressure on regulator
What to do when your output pressure increasing over time? This is most likely caused by dirt on o-ring on plastic screw.
In this video is shown how remove dirt and replace o-ring . In video is used Gunpower regulator. Procedure is same for others regulator.
Video how to take regulator out of regulator body
Unscrew airtube + cleaning
Before removing brass plug we need drain all air from airtube. When we unscrewing brass plug first time, airtube may need to be attached in a vice, but first try to unscrew the airtube in hand with a spanner. To avoid scratches and rotation airtube in vice is advisable to wrap the sandpaper around airtube(rough side out) and attached it. After unscrewing the brass plug we clean o-ring and inside of the airtube. For cleaning we use a foam or lint free cloth. It is good to wash out the inside of the airtube with degreaser, or technical petrol, etc..
Remove the O-ring from brass plug. Spray regulators o-ring from outer side with silicone spray. Insert regulator into airtube so that it is possible to screw the brass plug and check the presence of the lower O-ring in the groove. By screwing plug we get regulator into correct position. Dont screw plug to the max, but leave a gap (between plug and airtube) about 0.5 mm.
Fill airtube with air through quick fill. ALWAYS drain pressure from airtube by using drain valve which come with rifle, never drain air quickly it can cause damage to piston in regulátor.
The pressure setting is done by using a flat screwdriver in the upper part of the regulator. When we setting regulator we rotate with inside plastic screw with groove. The output pressure is showed by location colored grooves on the inner plastic screw. The total rotation range of the output pressure is in the range from 100 to 150 bar and is approximately 3/4 turn.
Scale is starting on 100 bar (green color) and ends on 150 bar (red color). Scale is only approximate and course times may change slightly due to fatigue disc springs. Fill the airtube to the maximum pressure which is mentioned by manufacturer.
You must keep maximum cleanness in the entire pressure system (airtube and outer o-rings). Do not disassemble the regulator without previous approval, which will be awarded based on e-mail correspondence, where you provide the reason why it would be necessary to disassemble the regulator. In the case of breach this procedure you may damage the regulator function (fully assembled regulator is not simple and it is necessary to follow the correct procedure). For these reasons, the disassembly without previous consent,or failure exact installation procedure can not claim the warranty. Since regulator is not original part from the manufacturer’s, installation is on your own responsibility.
SKU: EKAB10024B1
Znamka: EK archery
Strelni daljnogled osnovne serije s križem prilagojenim za strljenaje s samostreli.
SKU: ASP11024
Daljnogled za manj močno zračno orožje. Daljnogled ni primeren za extra močne zračne puške!!!
SKU: ASG603430
Kovinska tarča za zračno puško. Tarča z Auto resetom - ko postrelite 4 spodnje tarče z zadetkom na zgornjo tarčo poskrbite, da se tarče povrnejo v prvoten položaj.
SKU: HATLOVILEC
Znamka: HATSAN arms
Lovilec diabol izdelan tudi za najmočnejše zračne puške. Priloženih 20 tarč.
SKU: HATAIRSTRIP635
Znamka: HATSAN arms
Air stripper pripomore k večji natančnosti streljanja, saj zmanjša zračno turbolenco, ko naboj izstreli iz cevi.
SKU: ASP19243
Znamka: ASG
Tok za revolverje s cevjo 6-8". Zasnovan je bil posebej za Dan Wesson in podobne revolverje. Material: imitacija usnja
SKU: WRH9069
Za modele Weihrauch HW 35, HW 80 in HW 90.
SKU: ASP19843
Odličen kovček na kolesih za lažji prenos orožja. Izdatne dimenzije omogočajo prenos tudi daljših pušk z vsemi dodatki ali 2 kosov orožja naenkrat.
SKU: HATCYLBT65
Znamka: HATSAN arms
Zračni Cilinder za pcp puške Hatsan, serije BT-65 255 cc
SKU: ALTREGUBULLMAS
Regulator pritiska za PCP ne poveča moči, ampak zagotavlja konstantne pritiske in s tem poveča natačnost.
SKU: HATAIRSTRIP55
Znamka: HATSAN arms
Air stripper pripomore k večji natančnosti streljanja, saj zmanjša zračno turbolenco, ko naboj izstreli iz cevi.